Permatex® High Temperature Sleeve Retainer
OEM specified. High temperature, up to 400ºF (204ºC), anaerobic adhesive that secures slip and press fit assemblies. Adds up to 3,000 PSI holding power. Restores fit to worn or out-of-tolerance assemblies. Prevents surface corrosion. Conforms to ASTM D5363 AN0411 (Mil-R-46082, Type II).
Cylinder sleeves, valve guides, valve seats, bearings and bushings, woodruff keys, and liner assemblies
Retaining bushings, cup plugs, gears, dowel pins, oil seals, ring gear bolts, differential lock pinswheel bearins, idler shafts, press fit bearings
- Clean and dry parts using Permatex® Surface Prep™ activator.
- Apply Sleeve Retainer to both parts and assemble with a turning motion.
- Parts fixture within 1 hour and are fully cured after 24 hours.
- Refer to the Technical Data Sheet for complete information.
NOTE: Sleeve Retainer works on metal parts. It is not recommended for plastics. To disassemble parts, weaken cured Sleeve Retainer by heating above 500°F (260°C); then use presses or pullers to separate components.
|US Part Number
||Canada Part Number
||6 ml tube, carded