Permatex® Bearing Mount for Relaxed Fits


OEM specified. High strength, medium viscosity anaerobic adhesive for slip fit assemblies. Provides 4,000 PSI shear strength on steel. Fixtures in 10 minutes at room temperature.



Suggested Applications: Replaces set screws, replaces clamp rings, replaces snap rings, wheel bearings, idler shaft, and press fit bearings



  1. Clean and dry parts using Permatex® Surface Prep™.

  2. Apply to both parts and assemble with a turning motion.

  3. Parts fixture within 1 hour and are fully cured after 24 hours.

  4. Refer to Technical Data Sheet.

NOTE: Works on metal parts. It is not recommended for plastics. To disassemble, weaken by heating above 500F (260C); then use presses or pullers to separate components.
US Part Number Canada Part Number Container Size Pack
68050 68050 50 ml bottle 6