Versatile, easy-to-use, general purpose epoxy adhesive is two-part adhesive and filler system that eliminates the need for welding or brazing. Sets in thirty minutes, no clamping needed. Clear appearance. Fills gaps and will not shrink. When cured, can be drilled, sanded, threaded or filed. Resistant to water and solvents. Temperature range -60°F to 180°F (-51°C to 82°C). Permanent strength up to 3500 PSI.
PROTECT: Work area must be protected from accidental spills.
CLEAN: Surfaces must be clean, dry and free of grease and oil.
PREPARE: Roughen smooth surfaces (using abrasives or sandpaper).
OPEN PACKAGE: Remove Syringe. Turn syringe nozzle end up and pull plunger back slightly (1/8”). Allow air bubbles to rise to top. Snap off and save storage cap.Push plunger to dispense equal amounts of hardener and resin onto discard-able surface such as a piece of cardboard. Mixing paddle will pop out from plunger. Pull back plunger to stopflow. Snap cap back on.
MIX THOROUGHLY: Thoroughly mix with paddle provided for two minutes until evenly colored.
APPLICATION: Apply small amount of mixture to both surfaces and assemble parts immediately (product sets in approximately 30 minutes). Remove any excess epoxy immediately.
CURE TIME: Usable strength is reached in 8 hours at 72ºF (22ºC). Cooler temperatures may require longer set time.
CLEAN-UP: Attach nozzle cap and store in molded tray.
WARNING: Adhesive will not bond most polyethylene or polypropylene plastics.