Versatile, easy-to-use, general purpose epoxy adhesive is two-part adhesive and filler system that eliminates the need for welding or brazing. Sets in one minute, no clamping needed. Clear appearance. Fills gaps and will not shrink. Resistant to water and solvents. Temperature range -60°F to 180°F (-51°C to 82°C). Permanent strength up to 2500 PSI.
PROTECT: Work area must be protected from accidental spills.
CLEAN: Surfaces must be clean, dry and free of grease and oil.
PREPARE: Roughen smooth surfaces (using abrasives or sandpaper).
OPEN PACKAGE: Remove Syringe. Turn syringe nozzle end up and pull plunger back slightly (1/8”). Allow air bubbles to rise to top. Snap off and save storage cap. Push plunger to dispense equal amounts of hardener and resin onto discard-able surface such as a piece of cardboard. Mixing paddle will pop out from plunger. Pull back plunger tostop flow. Snap cap back on.
MIX QUICKLY: Quickly and thoroughly mix until blue color turns clear (about 15 sec).
APPLICATION: Apply small amount of mixture to both surfaces and assemble parts immediately (product sets in approximately 60 seconds). Remove any excess epoxy immediately.
CURE TIME: Usable strength is reached in 1 hour at 72ºF (22ºC).Cooler temperatures may require longer set time.
CLEAN-UP: Attach nozzle cap and store in molded tray.
NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
Type the appropriate five-digit US Or Canadian part number(s) into the field and click on the Search button. If entering more than one five-digit part number, please separate by a comma. For example: 25224,25218,24010,27010