OEM specified. High temperature, up to 400ºF (204ºC), anaerobic adhesive that secures slip and press fit assemblies. Adds up to 3,000 PSI holding power. Restores fit to worn or out-of-tolerance assemblies. Prevents surface corrosion. Conforms to ASTM D5363 AN0411 (Mil-R-46082, Type II).
Clean and dry parts using Permatex® Surface Prep™ activator.
Apply Sleeve Retainer to both parts and assemble with a turning motion.
Parts fixture within 1 hour and are fully cured after 24 hours.
Refer to the Technical Data Sheet for complete information.
NOTE: Sleeve Retainer works on metal parts. It is not recommended for plastics. To disassemble parts, weaken cured Sleeve Retainer by heating above 500°F (260°C); then use presses or pullers to separate components.