DIRECTIONS: 1. For best results, surfaces should be clean and dry. 2. Remove black cap from nozzle top and turn nozzle counterclockwise 1-2 turns. 3. Depress finger trigger to dispense, applying a continuous 1/16″ to 1/4″ (2 to 6mm) bead to one surface, surrounding all bolt holes. 4. Turn nozzle clockwise until tight to close and replace nozzle cap. 5. Assemble parts immediately; finger tighten until material begins to squeeze out around flange. Let dry one hour then tighten to torque specifications. Allow 24 hours to fully cure before filling with fluids or returning to service. NOTE: Not to be used as a head gasket or on parts in contact with gasoline.