Directions: 1. For best results, surfaces should be clean and dry. 2. Cut nozzle and apply a continuous 1/16″ to 1/4″ (2 to 6mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. 3 Let dry for on hour then tighten to torque specifications, 4. Allow 24 hours to fully cure before filling with fluids or returning to service. 5. Replace cap after use. NOTE: Not recommended for use on head gasket or parts in contact with gasoline.
1Maximum temperature performance
2Sensor-safe, non-corrosive, RTV silicone
3OEM specified
4Temperature resistance up to 750°F (399°C) intermittent
5Resistant to high thermal cycling
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
