DIRECTIONS: 1. PROTECT: Work area must be protected from accidental spills. 2. CLEAN: Surfaces must be
clean, dry and free of grease and oil. 3. PREPARE: Roughen smooth surfaces (using abrasives or sandpaper)
4. OPEN PACKAGE: Remove syringe. Using a sharp blade, cut off tips of both nozzles. 5. DISPENSE: Depress
plunger to dispense Part A and Part B. Mix thoroughly on a clean, discardable surface for 2 to 3 minutes until
evenly colored. 6. APPLICATION: Apply a small amount of mixture to both surfaces and assemble parts
immediately (working time is approximately 5 min.). Remove any excess Plastic Weld immediately. 7. CURE
TIME: Usable strength is reached in four hours at 72°F (22°C). Cooler temperature may require longer set
time. 8. CLEAN-UP: Attach nozzle cap and store in molded tray. NOTE: Adhesive will not bond most polyethylene
or polypropylene plastics.
1Bonds hard and soft plastics in any combination
2Dries cream
3Permanent strength up to 3500 PSI
4Gap filling to 0.125"
5Sets in 5 minutes, cures in 10 minutes
