DIRECTIONS: 1. PROTECT: Work area must be protected from accidental spills. 2. CLEAN: Surfaces
must be clean, dry and free of grease and oil. 3. PREPARE: Roughen smooth surfaces (using abrasives
or sandpaper). 4. OPEN PACKAGE: Remove Syringe. Turn syringe nozzle end up and pull plunger back
slightly (1/8″). Allow air bubbles to rise to top. Snap off and save storage cap. Push plunger to dispense
equal amounts of hardener and resin onto discard-able surface such as a piece of cardboard. Mixing
paddle will pop out from plunger. Pull back plunger to stop flow. Snap cap back on. 5. MIX
THOROUGHLY: Thoroughly mix with paddle provided for two minutes until evenly colored.
6. APPLICATION: Apply small amount of mixture to both surfaces and assemble parts immediately
(product sets in approximately 4 – 6 minutes). Remove any excess epoxy immediately. 7. CURE
TIME: Usable strength is reached in 4 hours at 72°F (22°C). Cooler temperatures may require longer set
time. 8. CLEAN-UP: Attach nozzle cap and store in molded tray. WARNING: Adhesive will not bond most
polyethylene or polypropylene plastics
1Steel reinforced, multi-metal epoxy adhesive in 2 part syringe
2Ideal for bonding metal to metal and is grey in appearance
3Permanent strength up to 4500 PSI
4Can be drilled, filed and threaded, fills gaps and will not shrink
5Sets in 5 minutes, cures in 10 minutes
Looking to take your training to the next level? Register for Permatex’s free online- training portal to gain access to live training seminars, ASE-accredited courses, how-to videos and more.
For the professionals. By the professionals.
