DIRECTIONS: 1. PROTECT: Work area must be protected from accidental spills. 2. CLEAN: Surfaces must be clean, dry
and free of grease and oil. 3. PREPARE: Roughen smooth surfaces (using abrasives or sandpaper). 4. OPEN
PACKAGE: Remove tubes and use a sharp point to puncture seals. 5. DISPENSE: Squeeze tubes to dispense resin and
hardener. Thoroughly mix resin & hardener on a clean, discardable surface for 2 to 3 minutes until evenly colored.
6. APPLICATION: Apply a small amount of mixture to both surfaces and assemble parts immediately (working time is
approximately 4-6 min.). Remove any excess epoxy immediately. 7. CURE TIME: Usable strength is reached in four
hours at 72°F (22°C). Cooler temperatures may require longer set time. 8. CLEAN-UP: Attach nozzle caps and store in
molded tray. NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.
1Multi-metal epoxy; two part adhesive and filler system
2Dries dark grey
3Permanent strength up to 4500 PSI
4Can be drilled, filed and threaded
