""

Permatex

Mobile Navigation

PRODUCTS

US Part Number: 51531
Canada Part Number: 51550
US Part Number: 51531
US Part Number: 51580

Permatex® Anaerobic Flange Sealant


Category:

Flexible, gasketing material for use on rigid machined flanges with less than .015" gap. OEM approved – use where OE’s specify “anaerobic” gasket (cures in the absence of air). Withstands temperatures to 300°F (149°C). Eliminates preformed, pre-cut, paper, rubber and cork gaskets. Flexes with flanges that move in service.

Automobile

Suggested Applications:
For use on machined aluminum metal components; transmission pans, transmission case covers, transaxle casings, axle covers, gear cases, split crankcases, pumps, housings, and with o-ring replacement.

Motorcycle

Suggested Applications:
For use on machined aluminum metal components; transmission pans, transmission case covers, transaxle casings, axle covers, gear cases, split crankcases, pumps, housings, and with o-ring replacement.

Heavy Duty

Suggested Applications:
Case covers, power divider shaft housings, input/output power shafts, PTO covers to housing, cover housing gasket, differential, assembly to rear axle housing, power dividers, axle shaft flange

Marine

Suggested Applications:
Crank case flanges drive unit joints, and with o-ring replacement

US Item # CDN Item # Container Size Pack
515315155050 ml tube 10
5158051580300 ml cartridge 10
US Item # Tech Doc File
51531 TDS  SDS  Canada part # SDS
51580 SDS  Canada part # SDS

TO MAKE A GASKET:

  1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely.
  2. Spray Permatex® Surface Prep™ activator on one surface only. Allow to dry 1-2 minutes.
  3. Apply a continuous bead of sealant to the unprimed surface.
  4. Assemble mating surfaces with minimal lateral movement. Excess sealant can be wiped awaywith a cloth and shop solvent.

TO DRESS A GASKET:

  1. Clean both flange surfaces. Remove paint, dirt, grease or old gasket completely.
  2. Spray Permatex® Surface Prep™ activator to both flange surfaces. Allow to dry 1-2 minutes.
  3. Completely cover both sides of the precut gasket with sealant.
  4. Place coated gasket on flange, and assemble mating surfaces with minimal lateral movement.

print instruction print

Related Products

Tech Documents

Type the appropriate five-digit US Or Canadian part number(s) into the field and click on the Search button. If entering more than one five-digit part number, please separate by a comma. For example: 25224,25218,24010,27010

or