Directions: Surfaces should be clean and dry. Cut nozzle and apply a continuous 1/16″ to 1/4″ (2 to 6mm) bead of silicone to one surface, surrounding all bolt holes. Assemble parts immediately while silicone is still wet. Finger tighten until material begins to squeeze out around flange. Let dry for one hour then tighten to torque specifications. Allow 90 minutes to cure before filling with fluids or returning to service. Replace cap after use. NOTE: NOT recommended for use on head gaskets or parts in contact with gasoline.
1High flexibility and oil resistance
2Sensor-safe, non-corrosive, RTV silicone
3Resistant to gear oil, transmission fluid, coolant, oil and common shop fluids
4Quickly returns vehicle to service in just 90 minutes
5Resistant against weathering and thermal cycling without hardening, shrinking or cracking
