DIRECTIONS: 1. Clean and dry parts using Permatex Surface Prep® activator. 2. Apply
High Temperature Sleeve Retainer to both parts and assemble with a turning motion. 3. Parts
fixture within 1 hour and are fully cured after 24 hours. 4. Refer to Technical Data Sheet for
complete information.
NOTE: High Temperature Sleeve Retainer works on metal parts. It is not recommended for plastics. To
disassemble parts, weaken cured High Temperature Sleeve Retainer by heating above 500°F (260°C); then
use presses or pullers to separate components.
1High temperature, up to 400°F (204°C), anaerobic adhesive
2Secures slip and press fit assemblies
3Adds up to 3,000 PSI holding power
4Restores fit to worn or out-of-tolerance assemblies
5Prevents surface corrosion
