DIRECTIONS: 1. Clean and dry parts using Permatex Surface Prep® activator, Item# 24163 2. Shake tube of
High Strength Threadlocker well before each use. 3. Remove cap and snip nozzle tip. 4. Apply to threaded
areas and assemble parts. Refer to Technical Data Sheet for complete information.
NOTE: Threadlocker works on metal parts. It is not recommended for plastics. Cured product must be heated
to 500°F (260°C) before parts will separate.
1High strength threadlocker for heavy-duty applications 3/8" to 1" (10mm to 25mm)
2Especially well-suited for permanently locking studs and press fits
3Adds 3,000 PSI holding power on slip and press fit assemblies
4Locks against vibration loosening
5May require heat or special tools for removal
