DIRECTIONS: Parts should be clean and oil free.
1. Remove protective cap. 2. Gently squeeze to expose 1/8″ to
1/4″ of material beyond tip. 3. Apply threadlocker to leading
edge of male fitting, covering 5 to 6 threads. Avoid direct
contact of tip to metal surface.* 4. Assemble parts and tighten
to recommended torque. 5. Replace protective cap.
*If contact occurs, expose 1/16″ of material and wipe off with a clean towel.
Temperature range: -65°F to 300°F (-54°C to 150°C). Refer to
Technical Data Sheet for complete information.
NOTE: Permatex Threadlocker Gel should not be used on plastic
fittings. Do not use on food contact surfaces.
1High strength threadlocker for heavy-duty applications 3/8" to 1" (10mm to 25mm)
2Especially well-suited for permanently locking studs and press fits
3Adds 3,000 PSI holding power on slip and press fit assemblies
4May require heat or special tools for removal
5Gel formula provides "liquid reliability" without drips, globs, mess or waste
