DIRECTIONS: 1. Clean and dry parts using Permatex Surface Prep®. 2. Apply to both parts and assemble
with a turning motion. 3. Parts fixture within 1 hour and are fully cured after 24 hours. 4. Refer to Technical
Data Sheet. NOTE: Works on metal parts. It is not recommended for plastics. To disassemble, weaken by
heating above 500F (260C); then use presses or pullers to separate components.
Permatex’s Bearing Mount Relaxed Fit Adhesive is an OEM specified, high strength, medium viscosity anaerobic adhesive for slip fit assemblies. This Relaxed Fit Adhesive provides 2,800 PSI shear strength on steel and fixtures in 10 minutes at room temperature.
1High strength, medium viscosity anaerobic adhesive for slip fit assemblies