DIRECTIONS: 1. Clean and dry parts using Permatex Surface Prep® activator. 2. Apply Sleeve Retainer to both parts
and assemble with a turning motion. 3. Parts fixture within 1 hour and are fully cured after 24 hours. 4. Refer to the
Technical Data Sheet for complete information.
NOTE: Sleeve Retainer works on metal parts. It is not recommended for plastics. To disassemble parts, weaken cured Sleeve Retainer by heating
above 500°F (260°C); then use presses or pullers to separate components.
1High temperature, up to 400°F (204°C), anaerobic adhesive
2Secures slip and press fit assemblies
3Adds up to 3,000 PSI holding power
4Restores fit to worn or out-of-tolerance assemblies
5Prevents surface corrosion
