DIRECTIONS: 1. Clean and dry parts using Permatex Surface Prep® activator. 2. Assemble
parts and make final adjustments. 3. Apply Penetrating Grade Threadlocker where thread
enters parts. Refer to Technical Data Sheet for complete information.
NOTE: Threadlocker works on metal parts. It is not recommended for plastics. To disassemble parts, weaken
cured Penetrating Grade Threadlocker by heating above 500°F (260°C); then use hand tools to separate components.
1Low viscosity threadlocking liquid
2Wicks along threads of preassembled fasteners to secure them in place
3Applied after assembly
4Ideal for fasteners ranging from #2 to 1/2" (2.2 to 12mm)
5Removable with hand tools
