DIRECTIONS FOR USE: Parts should be clean and oil free.
1. Remove protective cap. 2. Gently squeeze to expose 1/8″ to
1/4″ of material beyond tip. 3. Apply threadlocker to leading
edge of male fitting, covering 5 to 6 threads. Avoid direct
contact of tip to metal surface.* 4. Assemble parts and tighten
to recommended torque. 5. Replace protective cap.
*If contact occurs, expose 1/16″ of material and wipe off with a clean towel.
Temperature range: -65°F to 300°F (-54°C to 150°C). Refer to
Technical Data Sheet for complete information.
NOTE: Permatex Threadlocker Gel should not be used on plastic
fittings. Do not use on food contact surfaces.